Knives & Blades

Regarded by many installers as the finest professional knife available. The blade can be advanced in 1/2 segment increments for precision control...

Pack of 50. The industry standard when it comes to snap blades for film and pattern cutting. Thirteen cutting edges per blade. Use in most standard...

Used for film pattern cutting and trimming. Features a molded plastic handle for maximum control and comfort. Right or left hand use.

These blades are double-honed for extreme sharpness and are 25% sharper than the standard duty carbon blade. Eight cutting edges per blade, 50 blad...

Stainless steel snap blades from the makers of the "Red Dot" knife. Use in 9mm and multi-blade cartridge knives. Pack of 50.

Pack of 10. The industry standard when it comes to snap blades for film and pattern cutting. Thirteen cutting edges per blade. Use in most standard...

Standard duty acute angle snap-off blade for use when precision is a must. Seven cutting edges per blade strip. Pack of 10.

The original Olfa stainless steel knife.

Now comes with two 30 degree blades installed but will accommodate standard 9mm blades as well. Used for film pattern cutting and trimming. Holds u...

Slim stainless steel body with a 30° angle blade for precision in pattern cutting. Great for graphics and paint protection. Use GT1052 replacement...

Standard carbon snap blades with superior sharpness and edge retention. This 9mm blade fits most standard duty knives and has 13 cutting edges per ...

This ergonomically correct knife features a comfortable rubber grip for better control and less fatigue.

Significantly improved over the original "Olfa Silver." Features right or left handuse, blade position auto-lock, and one-segment click-action.

All-purpose standard duty utility knife with stainless steel sliding holder and sturdy aluminum die cast grip for long lasting use. Ratchet auto-lo...

Used for film pattern cutting and trimming.

Chemical-resistant and heat-resistant polypropylene grip. Ratchet auto-lock slider locks blade in place while cutting. Right or left hand use.

NT BAD-21P 30° blade. 10 blades per pack, Carbon. FIts GT1051, GT026N and Gt027.

Holds up to five blades at a time giving you 65 new cutting segments per load.

Heavy-duty NT blades for use with the GT1019, GT111, & GT264. Pack of 50.

Replacement blades for GT111, GT264, & GT1019 heavy-duty knives. Triple-honed for extremely sharp edge. Ideal for cutting thick films, 7 mil or...

NT heavy-duty knife with ratchet auto-lock slider which locks the blade into place while cutting. Blade storage in handle. Use with 7 mil or greate...

Cartridge cutter with aluminum die-cast grip. Cartridge holds up to 5 blades.

Heavy-duty knife with breakaway points for use with security films 7 mil or greater. Blade storage in handle.

18mm replacement blades. Fits GT111, GT264, and GT1019. Pack of 5.