Installation Accessories

Gasket push stick.

Heavy-duty waist apron for easy access to tools while on the job.

13 pocket tool apron.

Use the official Flexfilm microfiber dash towel to soak up moisture on the dash while you work. Measures approximately 78" x 46.5".

Blue gasket push stick.

This device is used to carefully pull back gaskets for easy film-to-glass installations below the gasket. Rub rails are located at the base of all ...

Furno 300 Dual Temp Heat Gun with high, medium, low settings. (120 volt)

Heat-resistant gloves great for use during heat shrinking.

A convenient trim guide or use the curved edge to pull back gaskets.

Flexible squeegee that is great for tight corners and maneuvering around gaskets.

The window tinting industry's original braided water absorbent rope. Soak Shield is tucked between the glass and the deck to reduce the chances of ...

Smooth-It is designed to effectively and evenly smooth out the edge of most tools used for film installation. It works great on plastic and rubber ...

Blade disposal unit that can be emptied and reused.

Use along the top edge of roll down windows for a precise "micro-edge" finish (1/8"). Use GT137 as a replacement blade.

Use this tool to pull back on rubber gaskets to tuck film below the seal.

The window tinting industry's original braided water absorbent rope. Soak Shield is tucked between the glass and the deck to reduce the chances of ...

Smooth-It is designed to effectively and evenly smooth out the edge of most tools used for film installation. It works great on plastic and rubber ...

Impact resistant, with a 1300 watt heating element and heats up in two minutes with 2 hours of steaming per filling. Great for removing film and ad...

Smooth-It Replacement Mats are sold in a 3 pack. The black (600D) mat is a medium fabric that works best and faster on big or deep scratches. The g...

Smooth-It Replacement Mats are sold in a 3 pack. The black (600D) mat is a medium fabric that works best and faster on big or deep scratches. The g...

The window tinting industry's original braided water absorbent rope. Soak Shield is tucked between the glass and the deck to reduce the chances of ...

The J4000W has a large 1 gallon internal water reservoir and provides 2 hours of continuous steam before refilling. Go from Preheat mode to full st...

This model allows you to heat shrink in low or high fan speeds and has a variable temperature setting to fine tune the amount of heat needed for a ...

The window tinting industry's original braided water absorbent rope. Soak Shield is tucked between the glass and the deck to reduce the chances of ...

Designed for professional installers, the Bladeater holds your knife safely and securely, allows you to easily snap and discard blades into the rep...

Replacement well for Bladeater.

Designed to deliver rapid, precise cuts for thick gauge safety films. It is intended for precision pre-cutting on flat, square-edged tables.

Use with almost any handled squeegee to give extra leverage.

Replacement bottle for the J2W Jiffy Steamer (GT921).

Replacement fuse for the J2W Jiffy Steamer (GT921).